1/32 Huey Slick

[lgriffin]

That is really nice - real modeling.

Lee Griffin

[Bill L.]

It's shaping up nicely!

[Ryan K]

The detail work looks great Tony.

[Anthony Leger]

first generation new doors. Will likely tweak then recast. First time on the side door the windows were too close together so had a do over then needed the inside of the side door. All mods done with sheet or strip evergreen. I did use a few pieces of etch from the huey hog. I cast a piece I needed for the rotor mast so that will likely be my next picture.  Archer Rivets really were easy to use. Just try to be patient. You'll note where the glass would be is cellophane tape so when I cast the part I'd be able to get it out. On the inside of the front doors I tried to leave some space to make it easy to insert the glass. I intend to have the window partially open like often seen in photos.

[lgriffin]

That looks great, Tony. Real nice work there. Looking forward to seeing more.

Lee Griffin

[Ryan K]

Thanks those references you loaned me were quite helpful so far.

Not a problem, with glad they are helpful. You are putting them to good use.

[Anthony Leger]

Thanks those references you loaned me were quite helpful so far.

[Ryan K]

That looks great Tony.

[Anthony Leger]

Been slowly working through making stuff for the huey getting past various how to hurdles. This is also my attempt to speed up the Kitty Hawk release since inevitably they will release their promised kit though I'd have to fork out  the big price it'll cost at release.