In Progress Builds
-
This is my Tamiya humvee that I’m converting to an uparmored M1114. I bought the kit at minicon and it came with a bunch of resin additions however most would not quite be right. This is now a mix of those parts, some bits from cults3d I’ve adapted or plain redid. Others I drew up and then printed
-
Creating a diorama for the first time, using a mix of AK pigments, Army painter grass, and the Tamiya 109E4/7 kit converted to a jabo with a bomb rack from an Eduard 109. Figures are Zvezda, still figuring out where to put them. Interesting to note I almost completely ruined the paint by spraying Tamiya flat clear over not-dry-enough white … Continue reading "1/48 Bf 109E Jabo diorama"
-
Basic run down a 1880 mobile artillery piece. https://tanks-encyclopedia.com/gruson-fahrbare-panzerlafette-fahrpanzer/amp/ A friend in Bulgaria designed and 3D printed two guns pieces for me, a 3.7 cm and 5.7 cm guns. I am attempting to make the 3.7 gun standalone and the 5.7 gun in a little vignette emplacement with a figure in the pit. First up is the 3.7 cm. I … Continue reading "Gruson Fahrpanzer"
-
Here is a couple of pictures of my AmTech P-40 build. It has gone well so far getting the wings decent was a challenge for the dihedral that had me attaching a rubber band to hold the joint tight while the glue dried. Also the main gear are very basic in how the kit represents them. I had to reposition … Continue reading "1/48 P-40 build"
-
Calling on our P-40 experts I’ve seen some with interior green and others that look aluminum. Anyone can offer which to use… I’ve got mine painted green, but before I glue in I wanted to check
Viewing 1 - 5 of 5 discussions
You must be logged in to create new discussions.
